2.
Install the full length expansion card
3.
Install the GPU air shroud top
4. Follow the procedure listed in
5. Install any device drivers required for the card as described in the documentation for the card.
Optional serial COM port
This is a service technician replaceable part only.
Removing the serial COM port
The procedure to remove serial COM port from Riser 3 or 4 is same.
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the air shroud
NOTE:
The serial COM port is supported only in slot 4 or slot 8 of the expansion card riser.
Steps
1. Loosen the captive screws on the system.
2. Press the blue release tab or blue button on the riser and holding the edges lift the expansion card riser from the riser
connector on the system board.
3. Disconnect the serial COM port cable from the rear I/O board.
Figure 169. Disconnecting the serial COM port
4. Open the latch on the expansion card riser and slide the serial COM port out of the expansion card riser.
220
Installing and removing system components
riser.
cover.
After working inside your
Safety
instructions.
Before working inside your
or
remove the GPU air
shroud.
system.
system.