Steps
1. Align and insert the intrusion switch in the slot until it is firmly seated in the slot on the system.
NOTE:
Route the cable properly when you replace it to prevent the cable from being pinched or crimped.
2. Using a Phillips #2 screwdriver, tighten the screw that secures the intrusion switch on the intrusion switch slot.
3. Connect the intrusion switch cable to the connector on the system board.
Figure 192. Installing the intrusion switch
Next steps
1.
Install the air
shroud.
2. Follow the procedure listed in
Optional OCP card
Removing the OCP card shroud
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the expansion card
Steps
Hold the edges of the OCP shroud and lift the shroud out of the system.
After working inside your
Safety
instructions.
Before working inside your
riser.
system.
system.
Installing and removing system components
237