Dell PowerEdge R7615 Installation And Service Manual page 55

Table 54. Serial Communication details (continued)
Option
Failsafe Baud Rate
Remote Terminal Type
Redirection After Boot
System Profile Settings
To view the System Profile Settings screen, power on the system, press F2, and click System Setup Main Menu > System
BIOS > System Profile Settings.
Table 55. System Profile Settings details
Option
System Profile
CPU Power Management
Memory Frequency
Turbo Boost
C-States
Write Data CRC
Memory Patrol Scrub
Memory Refresh Rate
Workload Profile
PCI ASPM L1 Link Power
Management
Determinism Slider
Description
setup utility may not always revert this setting to the default setting of
Serial Device 1.
Specifies the failsafe baud rate for console redirection. The BIOS attempts to
determine the baud rate automatically. This failsafe baud rate is used only if
the attempt fails, and the value must not be changed. This option is set to
115200 by default.
Sets the remote console terminal type. This option is set to VT100/VT220 by
default.
Enables or disables the BIOS console redirection when the operating system is
loaded. This option is set to Enabled by default.
Description
Sets the system profile. If you set the System Profile option to a mode other than Custom,
the BIOS automatically sets the rest of the options. You can only change the rest of the
options if the mode is set to Custom. This option is set to Performance Per Watt (OS) by
default. Other options include Performance and Custom.
NOTE: All the parameters on the system profile setting screen are available only when
the System Profile option is set to Custom.
Sets the CPU power management. This option is set to OS DBPM by default. Other option
includes Maximum Performance.
Sets the speed of the system memory. You can select Maximum Performance or a specific
speed. This option is set to Maximum Performance by default.
Enables or disables the processor to operate in the turbo boost mode. This option is set to
Enabled by default.
Enables or disables the processor to operate in all available power states. C States allow the
processor to enter lower power states when idle. When set to Enabled (OS controlled) or
when set to Autonomous (if hardware controlled is supported), the processor can operate
in all available Power States to save power, but may increase memory latency and frequency
jitter. This option is set to Enabled by default.
When set to Enabled, DDR4 data bus issues are detected and corrected during 'write'
operations. Two extra cycles are required for CRC bit generation which impacts the
performance. Read-only unless System Profile is set to Custom. This option is set to
Disabled by default.
Sets the memory patrol scrub mode. This option is set to Standard by default.
Sets the memory refresh rate to either 1x or 2x. This option is set to 1x by default.
Allows optimization of performance based on the workload type. The Workload Profile
setting is not a state.Setting a Workload Profile is a one-time action that in turns modifies
various BIOS settings to be optimized for the requested workload type. This option is set to
Not Configured by default.
Enables or disables the PCI ASPM L1 Link Power Management. This option is set to Enabled
by default.
Set the system determinism by Power Determinism or Performance Determinism. This
option is set to Perfomance Determinism by default.
Pre-operating system management applications 55