Table of Contents
Advertisement
Next steps
1.
Replace the BOSS-N1 card carrier
Installing the BOSS-N1 card carrier blank
Prerequisites
1. Follow the safety guidelines listed in the
Steps
Align the blank with the BOSS-N1 module bay and push it into the bay until it clicks into place.
Figure 180. Installing the BOSS-N1 card carrier blank
Removing the BOSS-N1 module
The procedure to remove is the BOSS-N1 module with 4 x 2.5-inch rear drive module is similar.
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
Steps
1.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Pull and lift the BOSS-N1 card carrier retention latch lock to open.
2. Slide the BOSS-N1 card carrier out.
228
Installing and removing system components
blank.
Safety
instructions.
Safety
instructions.
Before working inside your
system.
Advertisement
Table of Contents
