Steps
1. Using a Phillips #2 screwdriver, loosen the captive screws on the front mounting front PERC module.
2. Slide the front mounting front PERC module to disengage from the connector on the drive backplane.
Figure 100. Removing the front mounting front PERC module
Next steps
1.
Replace the front mounting front PERC
Installing the front mounting front PERC module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3.
Remove the cooling fan cage
4.
Remove the drive backplane
5. If required,
remove the air shroud
6. If required,
remove the drive backplane
7. Route the cable properly to prevent the cable from being pinched or crimped.
NOTE:
Refer
Cable routing
Steps
1. Align the connectors and guide slots on the front mounting front PERC module with the connectors and guide pins on the
drive backplane.
2. Slide the front mounting front PERC module until the module is connected to the drive backplane.
3. Using a Phillips #2 screwdriver, tighten the captive screws on the front mounting front PERC module.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
138
Installing and removing system components
module.
Safety
instructions.
Before working inside your
assembly.
cover.
or
remove the GPU air
cover.
topic for more information.
system.
shroud.