Table of Contents
Advertisement
Table 110. Config10. R1U+R3B+R4Q (continued)
Card type
FOXCONN (BOSS)
Removing the expansion card risers
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the air shroud
4.
NOTE:
If BOSS-N1 module is installed, ensure to disconnect the BOSS-N1 power cable and Signal cable before removing
the Riser 1 cage.
5. If applicable, disconnect the cables from the expansion card or system board.
Steps
1. Loosen the captive screws on the riser and system.
2. Press the blue release tab or blue button on the riser and holding the edges lift the expansion card riser from the riser
connector on the system board.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
198
Installing and removing system components
Slot priority
Integrated slot
Safety
instructions.
Before working inside your
or
remove the GPU air
shroud.
Maximum number of cards
1
system.
Advertisement
Table of Contents
