Table of Contents
Advertisement
Steps
1. Using a Phillips # 2 screwdriver, remove the screws that secure the LAN on Motherboard (LOM) card and rear I/O board to
the system board.
2. Holding the edges, pull the LOM card or rear I/O board to disconnect from the connector on the system board.
Figure 208. Removing the LOM card and rear I/O board
Figure 209. Removing the LOM card and liquid cooling rear I/O board
Next steps
1.
Replace the LOM card and rear I/O
board.
Installing and removing system components
253
Advertisement
Table of Contents
