Table of Contents
Advertisement
4. If installed,
remove the air shroud
5.
Remove the cooling fan cage
6.
Remove the
drives.
7. Observe and disconnect the drive backplane cables from the connector on the system board and backplane.
NOTE:
Refer
Cable routing
NOTE:
To avoid damaging the backplane, ensure to move the control panel cables from the cable routing clips before
removing the backplane.
NOTE:
Route the cable properly when you replace it to prevent the cable from being pinched or crimped.
Steps
1. Align the slots on the drive backplane with the guides on the system.
2. Slide the drive backplane into the guides and lower the backplane until the blue release tab clicks into place.
Figure 68. Installing the drive backplane
Next steps
1. Connect the drive backplane cables to the connectors on the system board and backplane.
2.
Install the
drives.
3.
Install the cooling fan cage
4. If removed,
install the air shroud
5.
Install the drive backplane
6. Follow the procedure listed in
106
Installing and removing system components
or
remove the GPU air
assembly.
topic for more information.
assembly.
or
remove the GPU air shroud
cover.
After working inside your
shroud.
system.
Advertisement
Table of Contents
