Table of Contents
Advertisement
Figure 217. Installing the BOSS-N1 module blank
To install the BOSS-N1 module:
1. Install the BOSS-N1 module . To install the BOSS-N1 , see
2. Install the M.2 SSD. To install the M.2 SSD, see
NOTE:
Installing the BOSS-N1 card carrier does not require the system to be powered off. System shutdown is only
required when installing the BOSS-N1 controller card module.
To remove the BOSS-N1 module:
1. Power off the system and
2. Remove the M.2 SSD. To remove the M.2 SSD, see
3. Remove the BOSS-N1 module. To remove the BOSS-N1 controller card module, see
4. Install the BOSS-N1 module blank.
NOTE:
Removal of the BOSS-N1 card carrier does not require the system to be powered off. System shutdown is only
required when removing the BOSS-N1 module.
NOTE:
Disconnect the BOSS signal cable and the BOSS power cable before lifting the module from the system.
262
Upgrade Kits
installing the BOSS-N1
remove the system
cover.
installing the BOSS-N1
module.
Removing the BOSS-N1
module.
module.
Removing the BOSS-N1
module.
Advertisement
Table of Contents
