4.
Remove the drive backplane
5. If required,
remove the air shroud
6. If required,
remove the drive backplane
7. Disconnect all the cables, observe the cable routing.
NOTE:
Refer
Cable routing
Steps
1. Using a Phillips #2 screwdriver, loosen the captive screws on the rear mounting front PERC module.
2. Slide the rear mounting front PERC module to disengage from the connector on the drive backplane.
Figure 98. Removing the rear mounting front PERC module
Next steps
1.
Replace the rear mounting front PERC
Installing the rear mounting front PERC module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3.
Remove the cooling fan cage
4.
Remove the drive backplane
5. If required,
remove the air shroud
6. Route the cable properly to prevent the cable from being pinched or crimped.
NOTE:
Refer
Cable routing
136
Installing and removing system components
cover.
or
remove the GPU air
cover.
topic for more information.
module.
Safety
instructions.
Before working inside your
assembly.
cover.
or
remove the GPU air
topic for more information.
shroud..
system.
shroud.