Table of Contents
Advertisement
Figure 156. Installing the power interposer board
3. Reconnect the cables that are connected to the power interposer board (PIB) and also to the system board.
Next steps
1.
Install the 2U air
shroud.
2.
Install the drive cage
.
3.
Install the
PSU.
4. Follow the procedure listed in
Optional OCP card
Removing the OCP card
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the expansion card riser
NOTE:
The procedure to remove the OCP card is the same for Rear Accessed and Front Accessed configurations.
Steps
1. Open the blue latch to disengage the OCP card.
2. Push the OCP card towards the rear end of the system to disconnect from the connector on the system board.
3. Slide the OCP card out of the slot on the system.
After working inside your
Safety
instructions.
Before working inside your
3.
system.
system.
Installing and removing system components
181
Advertisement
Table of Contents
