Removing The Expansion Card Risers - Dell PowerEdge HS5620 Installation And Service Manual

Table 89. Configuration 2: R1D (continued)
Card type
Intel (OCP: 100Gb)
Mellanox (OCP: 100Gb)
Broadcom (OCP: 25Gb)
Intel (OCP: 25Gb)
Marvell (OCP: 25Gb)
Mellanox (OCP: 25Gb)
SolarFlare (OCP: 25Gb)
Broadcom (OCP: 10Gb)
Marvell (OCP: 10Gb)
Intel (OCP: 10Gb)
Broadcom (OCP: 1Gb)
Intel (OCP: 1Gb)
Dell BOSS N1 Module
NOTE: The serial COM card is not a real PCIe add-in card and has a dedicated slot on the system board.

Removing the expansion card risers

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the air shroud.
4. Disconnect all the riser cables from the system board.
Steps
For Riser 1C and Riser 1D, loosen the two thumb screws with Phillips #2 screwdriver and pull up the expansion card riser.
Slot priority
Integrated slot
Integrated slot
Integrated slot
Integrated slot
Not supported
Integrated slot
Not supported
Integrated slot
Not supported
Not supported
Integrated slot
Not supported
Integrated slot
Safety instructions.
Before working inside your
Maximum number of cards
1
1
1
1
NA
1
NA
1
NA
NA
1
NA
1
system.
Installing and removing system components 127