Table of Contents
Advertisement
2. Press the center tab to release the bracket from the system, and lift it away from the system.
Figure 35. Removing the side wall bracket
Next steps
1.
Replace the side wall
Installing the side wall bracket
There are two side wall brackets on either side of the system. The procedure to install them is same.
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. If required,
remove the drive backplane
4. If installed,
remove the air
5.
Remove the cooling fan cage
NOTE:
Ensure that you note the routing of the cables as you remove them from the system board. Route the cables
properly when you replace them to prevent the cables from being pinched or crimped.
Steps
1. Align the guide slots on the side wall bracket with the guides on the system and slide until the cover is seated firmly.
NOTE:
Route the cables through the side wall bracket.
2. Close the side wall bracket until the holder clicks into place.
74
Installing and removing system components
bracket.
Safety
Before working inside your
cover.
shroud.
assembly.
instructions.
system.
Advertisement
Table of Contents
