Table of Contents
Advertisement
Figure 38. Removing the side wall bracket
Next steps
1.
Install the side wall
bracket.
Installing the side wall bracket
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. If installed,
Remove the front
4.
Remove the drive backplane
5. If installed,
Remove the air
NOTE:
Ensure that you note the routing of the cables as you remove them from the system board. Route the cable
properly when you replace it to prevent the cable from being pinched or crimped.
Steps
1. Align the side wall bracket with the tabs on the chassis.
2. Press the side wall bracket with your thumbs until the bracket firmly clicks into place.
NOTE:
Route the cables through the side wall bracket.
3. Close the side wall bracket cover with your thumbs until the cover firmly clicks into place.
Safety
instructions.
Before working inside your
bezel.
cover.
shroud.
system.
Installing and removing system components
49
Advertisement
Table of Contents
