3. Route the cables properly through the cable guide and connect the cables to the connector on the system board.
Figure 70. Installing the drive backplane
Next steps
1.
Install the cooling fan cage
2.
Install all the
drives.
3. If removed,
install the air shroud
4.
Install the drive backplane
5. Connect the drive backplane cables to the connector on the system board.
6. Connect the drive backplane cables to the connector on the backplane.
7. Follow the procedure listed in
Side wall brackets
Removing the side wall bracket
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the backplane
4. If installed,
remove the air
5.
Remove the cooling fan
NOTE:
Ensure that you note the routing of the cables as you remove them from the system board. Route the cable
properly when you replace it to prevent the cable from being pinched or crimped.
Steps
1. Press the tab to release the side wall bracket cover.
104
Installing and removing system components
assembly.
or
install the GPU air
cover.
After working inside your
Safety
instructions.
Before working inside your
cover.
shroud.
assembly.
shroud.
system.
system.