Side Wall Brackets; Removing The Side Wall Bracket - Dell PowerEdge R960 Installation And Service Manual

Figure 56. Installing the drive backplane
Next steps
1. Connect the drive backplane cables to the connectors on the system board and backplane.
2. If removed, install the
3. Install the drives.
4. If removed, install the rear mounting front PERC
5. If removed, install the air shroud
6. Install the cooling fan cage
7. If removed, install the air shroud top
8. If removed, install the support
9. Follow the procedure listed in

Side wall brackets

Removing the side wall bracket

There are two side wall brackets on either side of the system. The procedure to remove is similar.
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the support bar.
4. Remove the air shroud top
5. Remove the cooling fan cage
6. If required, remove the air shroud
NOTE: Ensure that you note the routing of the cables as you remove them from the system board. Route the cables
properly when you replace them to prevent the cables from being pinched or crimped.
94 Installing and removing system components
PEM.
or install the GPU air
assembly.
cover.
bar.
After working inside your
Safety
Before working inside your
cover.
assembly.
or remove the GPU air
module.
shroud.
system.
instructions.
system.
shroud.