Figure 84. Removing the 2.5 inch drive rear backplane
Figure 85. 2 X 2.5 rear drive backplane
1
power connector
3
SAS cable connector
Next step
Install the 2.5 inch drive rear
Installing the 2.5 inch drive rear backplane
Prerequisite
Follow the safety guidelines listed in
Steps
1
Use the hooks on the rear drive cage as guides to align the drive backplane.
2
Lower the backplane into the system until it is firmly seated.
3
Using Phillips #2 screwdriver, replace the screws to secure the backplane to the rear drive cage.
134
Installing and removing system components
backplane.
Safety
instructions.
2
backplane signal connector
4
NVMe cable connector