Configuring Queuing - ZyXEL Communications XMG1930-30 User Manual

30-port multi-gigabit smart managed layer-2 switch, 30-port multi-gigabit smart managed layer-2 poe switch
Table of Contents

Advertisement

on that port. This queue then moves to the back of the list. The next queue is given an equal amount of
bandwidth, and then moves to the end of the list; and so on, depending on the number of queues
being used. This works in a looping fashion until a queue is empty.
Weighted Round Robin Scheduling (WRR) uses the same algorithm as round robin scheduling, but
services queues based on their priority and queue weight (the number you configure in the queue
Weight field) rather than a fixed amount of bandwidth. WRR is activated only when a port has more
traffic than it can handle. Queues with larger weights get more service than queues with smaller
weights. This queuing mechanism is highly efficient in that it divides any available bandwidth across the
different traffic queues and returns to queues that have not yet emptied.

49.2 Configuring Queuing

Use this screen to set priorities for the queues of the Switch. This distributes bandwidth across the different
traffic queues.
Click SWITCHING > QoS > Queuing Method to display the screen as shown below.
Figure 233 SWITCHING > QoS > Queuing Method
The following table describes the labels in this screen.
Table 174 SWITCHING > QoS > Queuing Method
LABEL
Port
*
Chapter 49 Queuing Method
DESCRIPTION
This label shows the port you are configuring.
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to set the
common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
XMG1930 Series User's Guide
338

Advertisement

Table of Contents
loading

This manual is also suitable for:

Xmg1930 series

Table of Contents