The following table describes the labels in this screen.
Table 179 SWITCHING > sFlow > Collector > Add/Edit
LABEL
DESCRIPTION
Collector
Enter the IP address of the sFlow collector.
Address
UDP Port
Enter a UDP port number the Switch uses to send sFlow datagram to the collector. If you change
the port here, make sure you change it on the collector, too. The default port is 6343.
Apply
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Clear
Click Clear to clear the fields to the factory defaults.
Cancel
Click Cancel to not save the configuration you make and return to the last screen.
Chapter 52 sFlow
XMG1930 Series User's Guide
347