Mld Snooping-Proxy; Mld Snooping-Proxy Vlan - ZyXEL Communications XMG1930-30 User Manual

Table 145 SWITCHING > Multicast > IPv6 Multicast > IPv6 Multicast Status (continued)
LABEL
Multicast Group
Group Timeout

45.7 MLD Snooping-proxy

Click SWITCHING > Multicast > IPv6 Multicast > MLD Snooping-proxy to display the screen as shown. See
Section 45.1 on page 291
Figure 204 SWITCHING > Multicast > IPv6 Multicast > MLD Snooping-proxy
The following table describes the fields in the above screen.
Table 146 SWITCHING > Multicast > IPv6 Multicast > MLD Snooping-proxy
LABEL
MLD Snooping-proxy
Use these settings to configure MLD snooping-proxy.
Active
802.1p Priority
Apply
Cancel

45.8 MLD Snooping-proxy VLAN

Click SWITCHING > Multicast > IPv6 Multicast > VLAN screen to display the screen as shown. See
45.1 on page 291
Chapter 45 Multicast
DESCRIPTION
This field displays IP multicast group addresses.
This field displays the time (in seconds) that elapses before the Switch removes a MLD group
membership entry if it does not receive report messages from the port.
for more information on multicasting.
DESCRIPTION
Enable the switch button to enable MLD snooping-proxy on the Switch to minimize MLD
control messages and allow better network performance.
Select a priority level (0 – 7) to which the Switch changes the priority in outgoing MLD
messages.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel
to save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
for more information on multicasting.
XMG1930 Series User's Guide
305
Section