Mld Snooping-Proxy Filtering - ZyXEL Communications XMG1930-30 User Manual

Table 149 SWITCHING > Multicast > IPv6 Multicast > Port Role Setting (continued)
LABEL
Leave Mode
Leave Timeout
Fast Leave Timeout
Apply
Cancel

45.10 MLD Snooping-proxy Filtering

Use this screen to configure the Switch's MLD filtering settings. Click the SWITCHING > Multicast > IPv6
Multicast > Filtering screen to display the screen as shown.
Chapter 45 Multicast
DESCRIPTION
This is configurable only when you select Downstream in the previous Port Role field.
Select the leave mode for the specified downstream ports in this VLAN.
This specifies whether the Switch removes an MLD snooping membership entry (learned
on a downstream port) immediately (Immediate) or wait for an MLD report before the
leave timeout (Normal) or fast leave timeout (Fast) when an MLD leave message is
received on this port from a host.
Enter the MLD snooping normal leave timeout (in milliseconds) the Switch uses to update
the forwarding table for the specified downstream ports.
This defines how many seconds the Switch waits for an MLD report before removing an
MLD snooping membership entry (learned on a downstream port) when an MLD Done
message is received on this port from a host.
Enter the fast leave timeout (in milliseconds) for the specified downstream ports.
This defines how many seconds the Switch waits for an MLD report before removing an
MLD snooping membership entry (learned on a downstream port) when an MLD Done
message is received on this port from a host.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Click Cancel to reset the fields to your previous configuration.
XMG1930 Series User's Guide
309