Mvr Configuration - ZyXEL Communications XMG1930-30 User Manual

The following table describes the fields in the above screen.
Table 153 SWITCHING > Multicast > IPv6 Multicast > Filtering Profile > Add Rule
LABEL
Profile Name
Start Address
End Address
Apply
Clear
Cancel

45.12 MVR Configuration

Use this screen to view and create multicast VLANs.
Click SWITCHING > Multicast > MVR to display the screen as shown next.
Note: You can create up to five multicast VLANs and up to 256 multicast rules on the Switch.
Note: Your Switch automatically creates a static VLAN (with the same VID) when you create
a multicast VLAN in this screen.
Figure 212 SWITCHING > Multicast > MVR
The following table describes the related labels in this screen.
Table 154 SWITCHING > Multicast > MVR
LABEL
VLAN
Active
Name
Mode
Source Port
Receiver Port
802.1p Priority
Chapter 45 Multicast
DESCRIPTION
Select a profile from the drop-down list to add a additional rule for the existing profile.
Type the starting multicast IPv6 address for a range of multicast IPv6 addresses that you want
to belong to the MLD filtering profile.
Type the ending multicast IPv6 address for a range of IPv6 addresses that you want to
belong to the MLD filtering profile.
If you want to add a single multicast IPv6 address, enter it in both the Start Address and End
Address fields.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Clear to clear the fields to the factory defaults.
Click Cancel to not save the configuration you make and return to the last screen.
DESCRIPTION
This field displays the multicast VLAN ID.
This field displays whether the multicast group is enabled or not.
This field displays the descriptive name for this setting.
This field displays the MVR mode.
This field displays the source port numbers.
This field displays the receiver port numbers.
This field displays the priority level.
XMG1930 Series User's Guide
313