Sflow Collector Configuration; Add/Edit Sflow Collector - ZyXEL Communications XMG1930-30 User Manual

Table 177 SWITCHING > sFlow (continued)
LABEL
Apply
Cancel

52.3 sFlow Collector Configuration

Click SWITCHING > sFlow > Collector to display the screen as shown. You may want to configure more
than one collector if the traffic load to be monitored is more than one collector can manage.
Note: You can configure up to four sFlow collectors in this screen.
Figure 238 SWITCHING > sFlow > Collector
The following table describes the labels in this screen.
Table 178 SWITCHING > sFlow > Collector
LABEL
Index
Collector
Address
UDP Port
Add/Edit
Delete

52.3.1 Add/Edit sFlow Collector

Click Add/Edit, or select an entry and click Add/Edit in the SWITHCING > sFlow > Collector screen to
display this screen.
Figure 239 SWITCHING > sFlow > Collector > Add/Edit
Chapter 52 sFlow
DESCRIPTION
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
DESCRIPTION
This field displays the index number of this entry.
This field displays IP address of the sFlow collector.
This field displays port number the Switch uses to send sFlow datagram to the collector.
Select an entry's check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Click Add/Edit to add a new entry or edit a selected one.
Click Delete to remove the selected entries.
XMG1930 Series User's Guide
346