Table of Contents
Advertisement
Figure 431 SYSTEM > General Setup
Note: The input string of any field in this screen should not contain [ ? ], [ | ], [ ' ], [ " ], or [ , ].
The following table describes the labels in this screen.
Table 332 SYSTEM > General Setup
LABEL
DESCRIPTION
System Name
Choose a descriptive name for identification purposes. This name consists of up to 64 printable
ASCII characters; spaces are allowed.
Location
Enter the geographic location of your Switch. You can use up to 128 printable ASCII
characters; spaces are allowed.
Contact Person's
Enter the name of the person in charge of this Switch. You can use up to 32 printable ASCII
Name
characters; spaces are allowed.
Use Time Server
Enter the time service protocol that your time server uses. Not all time servers support all
when Bootup
protocols, so you may have to use trial and error to find a protocol that works. The main
differences between them are the time format.
When you select the Daytime (RFC-867) format, the Switch displays the day, month, year and
time with no time zone adjustment. When you use this format it is recommended that you use a
Daytime timeserver within your geographical time zone.
Time (RFC-868) format displays a 4-byte integer giving the total number of seconds since 1970/
1/1 at 00:00:00.
NTP (RFC-1305) is similar to Time (RFC-868).
None is the default value. Enter the time manually. Each time you turn on the Switch, the time
and date will be reset to 2020-01-01 00:00:00.
Time Server IP
Enter the IP address or domain name of your timeserver. The Switch searches for the timeserver
Address
for up to 60 seconds.
Time Server Sync
Enter the period in minutes between each time server synchronization. The Switch checks the
Interval
time server after every synchronization interval.
Current Time
This field displays the time you open this menu (or refresh the menu).
Chapter 79 Networked AV Mode
XMG1930 Series User's Guide
588
Advertisement
Table of Contents
Troubleshooting
