Table of Contents
Advertisement
Figure 440 SYSTEM > SNMP > SNMP Trap Port
The following table describes the labels in this screen.
Table 341 SYSTEM > SNMP > SNMP Trap Port
LABEL
Options
Port
*
Active
Apply
Cancel
79.17 PORT
The following sections introduce the PORT screens.
Chapter 79 Networked AV Mode
DESCRIPTION
Select the trap type you want to configure here.
This field displays a port number.
Settings in this row apply to all ports.
Use this row only if you want to make some of the settings the same for all ports. Use this row
first to set the common settings and then make adjustments on a port-by-port basis.
Changes in this row are copied to all the ports as soon as you make them.
Select this check box to enable the trap type of SNMP traps on this port. The Switch sends the
related traps received on this port to the SNMP manager.
Clear this check box to disable the sending of SNMP traps on this port.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
XMG1930 Series User's Guide
599
Advertisement
Table of Contents
Troubleshooting
