Configuring Dscp Settings - ZyXEL Communications GS1350 Series User Manual

30.3.1 Configuring DSCP Settings

To change the DSCP-IEEE 802.1p mapping click the DSCP Setting link in the DiffServ screen to display the
screen as shown next.
Figure 175 IP Application > DiffServ > DSCP Setting
The following table describes the labels in this screen.
Table 111 IP Application > DiffServ > DSCP Setting
LABEL DESCRIPTION
0 ... 63 This is the DSCP classification identification number.
To set the IEEE 802.1p priority mapping, select the priority level from the drop-down list box.
Apply Click Apply to save your changes to the Switch's run-time memory. The Switch loses these changes if it
is turned off or loses power, so use the Save link on the top navigation panel to save your changes to
the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Chapter 30 Differentiated Services
GS1350 Series User's Guide
240