Mvr Configuration Example - ZyXEL Communications XMG1930-30 User Manual

The following table describes the labels in this screen.
Table 157 SWITCHING > Multicast > MVR > Group Setup > Add/Edit
LABEL
Multicast VLAN ID
Group Name
Start Address
End Address
Apply
Clear
Cancel

45.13.2 MVR Configuration Example

The following figure shows a network example where ports 1, 2 and 3 on the Switch belong to VLAN 1. In
addition, port 7 belongs to the multicast group with VID 200 to receive multicast traffic (the News and
Movie channels) from the remote streaming media server, S. Computers A, B and C in VLAN 1 are able
to receive the traffic.
Figure 216 MVR Configuration Example
To configure the MVR settings on the Switch, click the Add/Edit button in the SWITCHING > Multicast >
MVR screen. Create a multicast VLAN and set the receiver and source ports.
Chapter 45 Multicast
DESCRIPTION
Select a multicast VLAN ID (that you configured in the MVR screen) from the drop-down list
box.
Enter a descriptive name for identification purposes. You can enter up to 32 printable ASCII
characters except [ ? ], [ | ], [ ' ], [ " ] or [ , ].
Enter the starting IP multicast address of the multicast group in dotted decimal notation.
Enter the ending IP multicast address of the multicast group in dotted decimal notation.
Enter the same IP address as the Start Address field if you want to configure only one IP
address for a multicast group.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Clear to clear the fields to the factory defaults.
Click Cancel to not save the configuration you make and return to the last screen.
XMG1930 Series User's Guide
317