Table of Contents
Advertisement
Chapter 35 Link Layer Discovery Protocol (LLDP)
Table 121 PORT > LLDP > LLDP MED > LLDP-MED Location > Add/Edit (continued)
LABEL
DESCRIPTION
Longitude
Enter the longitude information. The value should be from 0º to 180º.
•
west
•
east
Altitude
Enter the altitude information. The value should be from –2097151 to 2097151 in meters or in
floors.
•
meters
•
floor
Datum
Select the appropriate geodetic datum used by GPS.
•
WGS84
•
NAD83-NAVD88
•
NAD83-MLLW
Civic Address
Enter the Civic Address by providing information such as Country, State, County, City, Street,
Number, ZIP code and other additional information. Enter at least 2 fields in this configuration
including the Country. The valid length of the Country field is 2 characters and all other fields
are up to 32 characters.
•
Country
•
State
•
County
•
City
•
Division
•
Neighbor
•
Street
•
Leading-Street-Direction
•
Street-Suffix
•
Trailing-Street-Suffix
•
House-Number
•
House-Number-Suffix
•
Landmark
•
Additional-Location
•
Name
•
Zip-Code
•
Building
•
Unit
•
Floor
•
Room-Number
•
Place-Type
•
Postal-Community-Name
•
Post-Office-Box
•
Additional-Code
ELIN Number
Enter a numerical digit string, corresponding to the ELIN identifier which is used during
emergency call setup to a traditional CAMA or ISDN trunk-based PSAP. The valid length is
from 10 to 25 characters.
Apply
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Clear
Click Clear to clear the fields to the factory defaults.
Cancel
Click Cancel to not save the configuration you make and return to the last screen.
XMG1930 Series User's Guide
254
Advertisement
Table of Contents
Troubleshooting
