Anti-Arpscan Setup - ZyXEL Communications XMG1930-30 User Manual

Figure 349
The following table describes the fields in the above screen.
Table 273 SECURITY > Anti-Arpscan > Anti-Arpscan Host Status
LABEL
Clear Filtered host
A filtered host is a blocked IP address.
Port List
Filtered host
This table lists information on blocked hosts.
Index
Host IP
MAC Address
VLAN
Port
State

69.4 Anti-Arpscan Setup

Use this screen to enable Anti-Arpscan, set port and host thresholds as well as configure ports to be
trusted or untrusted. To open this screen, click SECURITY > Anti-Arpscan > Anti-Arpscan Setup.
Chapter 69 Anti-Arpscan
SECURITY > Anti-Arpscan > Anti-Arpscan Host Status
DESCRIPTION
Enter a port number or a series of port numbers separated by commas and spaces, and
then click Clear to unblock all hosts connected to these ports.
This displays the index number of an IP address (a host) that has been blocked.
This displays the IP address of the blocked host.
This displays the MAC address of the blocked host.
This displays the VLAN ID that shows which VLAN the blocked host is in.
This displays the port number to which the blocked host is connected.
This shows Err-Disable if the ARP-request rate from this host is over the threshold. Forwarding
hosts are not displayed.
XMG1930 Series User's Guide
489