Add Igmp Filtering Profile - ZyXEL Communications XMG1930-30 User Manual

The following table describes the labels in this screen.
Table 353 SWITCHING > Multicast> IGMP Filtering Profile
LABEL
Profile Name
Start Address
End Address
Add Profile
Add Rule
Delete

79.31.1 Add IGMP Filtering Profile

To access this screen, click the Add Profile button in the SWITCHING > Multicast > IGMP Filtering Profile
screen.
Figure 455 SWITCHING > Multicast > IGMP Filtering Profile > Add Profile
The following table describes the labels in this screen.
Table 354 SWITCHING > Multicast > IGMP Filtering Profile > Add Profile
LABEL
Profile Name
Start Address
End Address
Apply
Clear
Cancel
Chapter 79 Networked AV Mode
DESCRIPTION
This field displays the descriptive name of the profile.
This field displays the start of the multicast address range.
This field displays the end of the multicast address range.
Select an entry's check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Click this to add a new IGMP filtering profile.
Click Add Rule to add a new rule and specify the profile it belongs to in the Add Rule screen.
You can also select a profile entry and click Add Rule to add an additional rule for the
selected profile.
Select a profile and click Delete to remove the selected profile and the accompanying rules.
Select a rule from a profile and click Delete to remove the selected rule.
DESCRIPTION
Enter a descriptive name for the profile for identification purposes. You can enter up to 32
printable ASCII characters except [ ? ], [ | ], [ ' ], [ " ] or [ , ].
Type the starting multicast IP address for a range of multicast IP addresses that you want to
belong to the IGMP filter profile.
Type the ending multicast IP address for a range of IP addresses that you want to belong to
the IGMP filter profile. If you want to add a single multicast IP address, enter it in both the Start
Address and End Address fields.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Clear to clear the fields to the factory defaults.
Click Cancel to not save the configuration you make and return to the last screen.
XMG1930 Series User's Guide
621