Table of Contents
Advertisement
Table 282 SECURITY > Errdisable > Errdisable Detect (continued)
LABEL
Mode
Apply
Cancel
72.5 Error-Disable Recovery Setup
Use this screen to configure the Switch to automatically undo an action after the error is gone. Click
SECURITY > Errdisable > Errdisable Recovery to display the screen as shown.
Figure 360 SECURITY > Errdisable > Errdisable Recovery (Without Access L3 License)
Chapter 72 Error-Disable
DESCRIPTION
Select the action that the Switch takes when the number of control packets exceed the rate
limit on a port, set in the SECURITY > Errdisable > CPU Protection screen.
•
inactive-port – The Switch disables the port on which the control packets are received.
•
inactive-reason – The Switch drops all the specified control packets (such as BPDU) on the
port.
•
rate-limitation – The Switch drops the additional control packets the ports has to handle in
every one second.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
XMG1930 Series User's Guide
503
Advertisement
Table of Contents
Troubleshooting
