Configuring Dscp Settings - ZyXEL Communications GS1920v2 Series User Manual

The following table shows the default DSCP-to-IEEE802.1p mapping.
Table 150 Default DSCP-IEEE 802.1p Mapping
DSCP VALUE
IEEE 802.1p
36.3.1 C o nfig uring DSC P Se tting s
To change the DSCP-IEEE 802.1p mapping click the
screen as shown next.
Fig ure 230
The following table describes the labels in this screen.
Table 151 IP Application > DiffServ > DSCP Setting
L ABEL DESC RIPT IO N
0 ... 63 This is the DSCP classification identification number.
To set the IEEE 802.1p priority mapping, select the priority level from the drop-down list box.
Apply Click
is turned off or loses power, so use the
the non-volatile memory when you are done configuring.
Cancel Click
Chapter 36 Differentiated Services
0 – 7 8 – 15
0 1
IP Application > DiffServ > DSCP Setting
to save your changes to the Switch's run-time memory. The Switch loses these changes if it
Apply
to begin configuring this screen afresh.
C a nc e l
GS1920v2 Series User's Guide
16 – 23 24 – 31 32 – 39
2 3 4
DSC P Se tting
link on the top navigation panel to save your changes to
Sa ve
322
40 – 47 48 – 55 56 – 63
5 6 7
link in the screen to display the
DiffSe rv