ZyXEL Communications XMG1930-30 User Manual page 492

Figure 352 SECURITY > Anti-Arpscan > Anti-Arpscan Trust Host > Add/Edit
The following table describes the fields in the above screen.
Table 276 SECURITY > Anti-Arpscan > Anti-Arpscan Trust Host > Add/Edit
LABEL DESCRIPTION
Name Type a descriptive name of up to 32 printable ASCII (except [ ? ], [ | ], [ ' ], [ " ] or [ , ])
characters to identify this host.
Host IP Type the IP address of the host.
Mask A trusted host may consist of a subnet of IP addresses. Type a subnet mask to create a
single host or a subnet of hosts.
Apply Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Clear Click Clear to clear the fields to the factory defaults.
Cancel Click Cancel to not save the configuration you make and return to the last screen.
Chapter 69 Anti-Arpscan
XMG1930 Series User's Guide
492