ZyXEL Communications XMG1930-30 User Manual page 93

Table 30 Navigation Panel Links (Standard Mode) (continued)
LINK DESCRIPTION
VLAN Isolation This link takes you to a screen where you can block traffic between ports in a VLAN on the Switch.
VLAN Mapping This link takes you to screens where you can configure VLAN mapping settings on the Switch.
VLAN Stacking This link takes you to screens where you can activate and configure VLAN stacking.
NETWORKING
ARP Setup Click the link to unfold the following sub-link menu.
ARP This link takes you to a screen where you can configure ARP learning mode on a per-port basis.
Learning
Static ARP This link takes you to a screen where you can create static ARP entries which do not age out.
DHCP Click the link to unfold the following sub-link menu.
DHCPv4 This link takes you to screens where you can view DHCPv4 relay status, mode, and configure
Relay
DHCPv4 relay settings.
DHCPv6 This link takes you to a screen where you can enable and configure DHCPv6 relay.
Relay
DHCP This link takes you to a screen where you can specify whether ports are trusted or untrusted ports
Server
for DHCP packets.
Guard
Static Routing Click the link to unfold the following sub-link menu.
IPv4 Static This link takes you to a screen where you can configure IPv4 static routes. A static route defines
Route
how the Switch should forward traffic by destination IP address and subnet mask.
IPv6 Static This link takes you to a screen where you can configure IPv6 static routes. A static route defines
Route
how the Switch should forward traffic by destination IP address and prefix length.
SECURITY
AAA Click the link to unfold the following sub-link menu.
RADIUS This link takes you to a screen where you can configure your RADIUS (Remote Authentication Dial-
Server
In User Service) server settings for authentication.
Setup
TACACS+ This link takes you to a screen where you can configure your TACACS+ (Terminal Access Control-
Server
ler Access Control System Plus) server settings for authentication.
Setup
AAA Setup This link takes you to a screen where you can configure authentication, authorization and
accounting services through external servers. The external servers can be either RADIUS or
TACACS+ (Terminal Access Controller Access Control System Plus).
Access Control Click the link to unfold the following sub-link menu.
Service This link takes you to a screen where you can decide what services you may use to access the
Access
Switch.
Control
Remote This link takes you to a screen where you can specify a group of one or more "trusted computers"
Managem
from which an administrator may use a service to manage the Switch.
ent
Account This link takes you to a screen where you can configure account security settings on the Switch.
Security
ACL Click the link to unfold the following sub-link menu.
Classifier This link takes you to screens where you can configure the Switch to group packets based on the
specified criteria.
Policy Rule This link takes you to a screen where you can configure the Switch to perform special treatment
on the grouped packets.
Anti-Arpscan This link takes you to screens where you can enable anti-arpscan on the Switch and ports, and
view the port state. You can also create trusted hosts, view blocked hosts and unblock them.
BPDU Guard This link takes you to screens where you can enable BPDU guard on the Switch and ports, and
view the port state.
Storm Control This link takes you to a screen to set up broadcast filters.
XMG1930 Series User's Guide
93