ZyXEL Communications XMG1930-30 User Manual page 362

Figure 250 SWITCHING > Spanning Tree Protocol > MRSTP
The following table describes the labels in this screen.
Table 189 SWITCHING > Spanning Tree Protocol > MRSTP
LABEL DESCRIPTION
Tree This is the index number of the STP trees.
Active Select this check box to activate an STP tree. Clear this check box to disable an STP tree.
Note: You must also activate Multiple Rapid Spanning Tree (MRSTP) in the
Bridge Priority Bridge priority is used in determining the root switch, root port and designated port. The switch
with the highest priority (lowest numeric value) becomes the STP root switch. If all switches
have the same priority, the switch with the lowest MAC address will then become the root
switch. Select a value from the drop-down list box.
The lower the numeric value you assign, the higher the priority for this bridge.
Bridge Priority determines the root bridge, which in turn determines Hello Time, Max Age and
Forwarding Delay.
Hello Time This is the time interval in seconds between BPDU (Bridge Protocol Data Units) configuration
message generations by the root switch. The allowed range is 1 to 10 seconds.
Chapter 53 Spanning Tree Protocol
SWITHCING > Spanning Tree Protocol > Spanning Tree Setup screen to enable
MRSTP on the Switch.
XMG1930 Series User's Guide
362