Add/Edit Ipv6 Static Route - ZyXEL Communications XMG1930-30 User Manual

Table 248 NETWORKING > Static Routing > IPv6 Static Route (continued)
LABEL
Add/Edit
Delete

63.3.1 Add/Edit IPv6 Static Route

Click Add/Edit, or select an entry and click Add/Edit in the NETWORKING > Static Routing > IPv6 Static
Route to display this screen.
Figure 322 NETWORKING > Static Routing > IPv6 Static Route > Add/Edit
The following table describes the related labels you use to create a static route.
Table 249 NETWORKING > Static Routing > IPv6 Static Route > Add/Edit
LABEL
Interface Type
Interface ID
Route
Destination
Prefix Length
Next Hop
Apply
Clear
Cancel
Chapter 63 Static Route
DESCRIPTION
Select an entry's check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Click Add/Edit to add a new entry or edit a selected one.
Click Delete to remove the selected entries.
DESCRIPTION
Select the type of the IPv6 interface through which the IPv6 packets are forwarded.
The Switch supports only the VLAN interface type at the time of writing.
Enter the ID number of the IPv6 interface through which the IPv6 packets are forwarded.
Enter the IPv6 address of the final destination.
Enter the prefix length number of up to 64 for this destination.
Enter the IPv6 address of the next-hop router.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Clear to clear the fields to the factory defaults.
Click Cancel to not save the configuration you make and return to the last screen.
XMG1930 Series User's Guide
444