88 Chapter 7 Replacing basic chassis components
8
9
10
11
Replacing the DVD-ROM/CDRW drive
Your 600r server comes with a DVD-ROM/CDRW drive installed. The DVD
drive is not hot-swappable. You must power down the system to replace
the DVD drive.
You must also remove the server cover and the front bezel to replace the
DVD drive.
Requirements
You need a Phillips (cross head) screwdriver, #1 and #2 bits.
To replace the DVD drive
Step
1
2
3
4
5
Copyright © 2007, Nortel Networks
.
Note: Press the riser card straight down into the slot. Press
down on the riser card, not on the MPB96 card. Tipping it in
the slot while installing it or pressing on the MPB96 card can
damage the riser card, board slot, or the MPB96 card.
Tighten the captive screw that holds the riser assembly to the
chassis. For details, see A,
(page
87).
Replace the server cover.
Take off the ESD strap.
Plug in the peripheral devices and Ethernet cables, connect the AC
power cords, and restart the server.
Action
Power down the server, unplug all peripheral devices and Ethernet
cables, and disconnect the AC power.
Remove the server cover. For instructions, see
replacing the server cover" (page
Remove the front bezel. For instructions, see
replacing the front bezel" (page
Attach the ESD strap to your wrist and attach the other end to a
known grounded connection.
At the rear of the DVD-ROM drive, push outward on the cable
retention clips on each side of the DVD-ROM data cable. Releasing
the retention clips pushes the connector from the drive.
Nortel CallPilot
600r Server Maintenance and Diagnostics
NN44200-703 01.04 Standard
5.0 25 April 2007
Figure 24 "Removing riser from chassis"
—End—
77).
75).
"Removing and
"Removing and