To Configure The Voice Messaging Dn; To Leave A Message - Nortel T1/SMDI Configuration Manual

Testing the CallPilot installation

To configure the Voice Messaging DN

Note: If you have already configured a Voice Messaging CDN in the
Configuration Wizard, then you can skip this procedure. If you are not sure,
continue with this procedure to verify that a Voice Messaging CDN is
present, or to configure one if necessary.
1 Click System
Result: The Service Directory Number window appears.
2 Click New.
Result: The SDN Detail window appears.
3 In the Service DN box, type the primary Voice Messaging DN for
CallPilot.
Note: If there are no voice channels installed on CallPilot, then use the
fax or speech recognition primary DN as the Voice Messaging DN for
these tests. You can still use the Voice Messaging application as
described in this procedure.
4 In the Application Name box, select Voice Messaging.
5 In the Media Type box, select Voice.
Note: If there are no voice channels installed on CallPilot, then select
Fax or Speech Recognition based on the DN that you specified in step 3.
6 Click Save.

To leave a message

1 From any active telephone set connected to the switch, dial the Voice
Messaging Service DN that you have created.
Result: CallPilot plays the following prompt: "CallPilot from Nortel
Networks. Mailbox?"
Note: If CallPilot does not answer the call or you do not hear a prompt,
then check that the call channels and multimedia channels are in Idle
state, as described in "Verifying that each call channel and multimedia
channel is functioning properly" on page 145.
142
➝
Service Directory Number.
Standard 1.13
CallPilot