Installing The Cx32-2 - Siemens SIMOTION D4 5-2 Series Commissioning And Hardware Installation Manual

2.3.3

Installing the CX32-2

Overview
The CX32-2 can be installed in several ways.
Mounting the CX32-2 directly on a line module in booksize format
The CX32-2 can be mounted on the side wall of a SINAMICS S120 line module. The
mounting fixtures required for this are supplied with the SINAMICS S120 line module.
The SINAMICS S120 line module has five mounting fixtures on the left side. To mount the
control unit, proceed as follows (the steps are shown in the figure):
1. Attach the CX32-2 to the left side of the SINAMICS S120 line module. Position the
2. Push the two units together.
3. Press down on the module until the unit engages and is securely connected to the
1
Figure 2-8
SIMOTION D4x5-2
Commissioning and Hardware Installation Manual, 02/2012
CX32-2 a few millimeters higher than the line module. The mounting fixtures fit exactly in
the five cutouts on the module.
SINAMICS S120 line module.
The module is now flush with the line module at the top and front.
Steps in mounting the CX32-2 on a booksize line module
2.3 Installing supplementary system components
3
2
Installing
35