Siemens SIMOTION D4 5-2 Series Commissioning And Hardware Installation Manual page 190

Commissioning (software)
6.3 Performing an online configuration for the D4x5-2
Note
The components' firmware is upgraded or downgraded automatically based on the FW
version on the CompactFlash card and the FW version on the SINAMICS components
(DRIVE-CLiQ components, TB30, CBE30-2, PM340, etc.).
The update procedure can take several minutes and is indicated in the "Automatic
Configuration" dialog box by the following message:
State of the drive unit: Automatic FW update of DRIVE-CLiQ components
A firmware update on DRIVE-CLiQ components is indicated by the RDY LED flashing red
and green:
• FW update running: RDY LED flashes slowly (0.5 Hz)
• FW update complete: RDY LED flashes quickly (2 Hz)
These flashing patterns are also displayed on the yellow RDY LED on the
SIMOTION D/CX32-2 and indicate that a FW update is being carried out on components
connected to the SIMOTION D/CX32-2 or that all components have completed the FW
update.
Go offline once all the FW updates have been completed. POWER ON the
upgraded/downgraded components.
CBE30-2 option board:
During the firmware update, the OPT LED of the SIMOTION D module and the SYNC
LED of the CBE30-2 flash green.
7. At the end of the automatic configuration, you are prompted whether you want to "Go
8. Execute the "Copy RAM to ROM ..." function on the D4x5-2 and on the SINAMICS
190
OFFLINE" or "Stay ONLINE" with the drive unit.
Figure 6-24 Automatic configuration completed
Integrated. This saves the project on the CompactFlash card so that it does not need to
be reloaded after switching off and on.
Commissioning and Hardware Installation Manual, 02/2012
SIMOTION D4x5-2