Siemens SIMOTION D4 5-2 Series Commissioning And Hardware Installation Manual page 32

Installing
2.2 Installing the SIMOTION D4x5-2
Procedure
1. Remove the spacers (screws: M3, Torx T10).
2. Fit the seal around the cooling fins of the control unit.
3. Loosen the three M3 screws (screws: M3, Torx T10) on the upper clip and push the clip
4. Tighten up the three screws on the clip again (0.8 Nm tightening torque).
5. Push the control unit with the heat sink through the panel cutout.
6. Fasten the control unit directly on the rear wall of the control cabinet with an M6 screw at
32
Figure 2-5 Mounting the seal
up until the upper hole protrudes beyond the housing.
the top and bottom, tightening torque: 6 Nm (see
①
in the "Panel cutout" figure).
Commissioning and Hardware Installation Manual, 02/2012
SIMOTION D4x5-2