Replacing The Console Or Auxiliary Cable; Removing And Inserting The Compactflash Card; Figure 42: Routing Engine Interface Ports; Figure 43: Console And Auxiliary Serial Port Connector - Juniper M7I Hardware Manual

M7i Multiservice Edge Router Hardware Guide
Related
Documentation

Removing and Inserting the CompactFlash Card

100

Figure 42: Routing Engine Interface Ports

Replacing the Console or Auxiliary Cable

If a cable is already connected to the
to remove it:
Turn off the power to the console or auxiliary device.
1.
Unscrew the screws that secure the cable connector to the port, using a 2.5-mm
2.
flat-blade screwdriver if necessary.
Pull the cable connector straight out of the port.
3.
Disconnect the cable from the console or auxiliary device.
4.
To connect the new cable, follow these steps:
Plug the female end of the replacement serial cable into the
1.
port (see "Replacing the Management Ethernet Cable" on page 99).
Tighten the screws on the connector.
2.
Power on the auxiliary or console device.
3.

Figure 43: Console and Auxiliary Serial Port Connector

Fiber-Optic and Network Cable Specifications for the M7i Router on page 174
M7i Chassis Description on page 6
FIC Specifications for the M7i Router on page 173
The CompactFlash card is an optional component of the M7i router. If installed, it provides
primary storage for the router. It can accommodate software images, configuration files,
and microcode.
To remove, insert and configure an CompactFlash card, perform the following procedures:
Removing the CompactFlash Card from a Routing Engine on page 101
Inserting the CompactFlash Card on page 101
Configuring the CompactFlash Card on page 102
or
CONSOLE AUX/MODEM
CONSOLE
Copyright © 2010, Juniper Networks, Inc.
port, follow these steps
or
AUX/MODEM