Nortel Meridian SL-100 SE Replacement page 215

215 MCRM-S card replacement procedures
NT6X87
in an MCRM-S LCME
13
14
15
16
17
18
19
20
21
22
23
24
555-4031-547 Standard 12.02 July 2002
(continued)
CAUTION
Hot materials
Exercise care when handling the line card.
The line feed resistor may be hot.
To remove the line card, slide a card shroud over the card to be
removed and an adjacent card. (If there is not an adjacent card
on either side, do not use the card shroud.)
Grasp the edge of the card with a line card extractor at a point
midway between the top and bottom edges. Hold the extractor in
the right hand.
Squeeze the handles of the extractor together to grasp the card
tightly.
Hold the front cover of the line drawer to steady it with the left
hand.
Pull the extractor away from the drawer and the card will unplug
from its socket on the drawer backplane.
Continue pulling the card with the extractor until the card is clear
of the shroud.
Insert the removed card into the ESD container and store per
local procedures.
To replace the faulty card, remove the replacement card from the
ESD container.
Slide the card in the shroud guide slots towards the drawer
backplane.
Hold the front cover of the line drawer with the left hand to steady
it.
Grasp the top and bottom edges of the card with the fingers of
the right hand.
Push the card toward the backplane until it plugs fully into the
backplane socket.