Table of Contents
Advertisement
About this document
Purpose
This book provides information about replacing cards in Nortel Networks
equipment. It is intended for personnel involved in the maintenance of the
Meridian SL-100 SE switch.
This manual applies to offices that have the MSL 15 software release. Unless
the document is revised, it also applies to offices that have software releases
greater than MSL15.
Note: The MSL15 software delivery is part of an on-going evolution. This
book is one of several transitional documents that must be used with the
following DMS-100 counterparts for the full complement of
documentation:
•
Disregard the signaling point (SP), Traffic Operation Position System (TOPS).
and SuperNode Data Manager (SDM) information as it does not apply to the
Meridian SL-100 switch.
How to check the version and issue of this document
The version and issue of the document are indicated by numbers, for example,
01.01.
The first two digits indicate the version. The version number increases each
time the document is updated to support a new software release. For example,
the first release of a document is 01.01. In the next software release cycle, the
first release of the same document is 02.01.
The second two digits indicate the issue. The issue number increases each
time the document is revised but rereleased in the same software release cycle.
For example, the second release of a document in the same software release
cycle is 01.02.
Meridian SL-100 SE Commercial Systems Card Replacement Procedures MSL15
NA DMS-100 Card Replacement Procedures,
297-8001-547
xi
Advertisement
Table of Contents
