Connecting An Ac Power Cord To The Acx500 Outdoor Router - Juniper ACX500 Hardware Manual

NOTE: For information about connecting to external DC power sources, see the instructions
for your site.
9. Switch on the external circuit breakers to provide voltage to the DC power source cable leads.
Observe the system LED on the front of the router. If the DC power cable is correctly installed and
functioning normally, the system LED lights green steadily. If the status LED indicates that the power
supply is not functioning normally, repeat the installation and cabling procedures.
Figure 58: Connecting DC Power to the Router
SEE ALSO
ACX500 DC Power Specifications | 73
ACX500 DC Power Electrical Safety Guidelines | 239

Connecting an AC Power Cord to the ACX500 Outdoor Router

To connect AC power to the router, you need the following tools:
• Electrostatic discharge (ESD) grounding wrist strap
• AC power cord for the ACX500 outdoor router (not provided, must be purchased separately)
NOTE: Use the power cord that is purchased from Juniper Networks, and is compatible with the
ACX500 outdoor router. Using a power cord other than that is provided by Juniper Networks
165