Juniper ACX500 Hardware Manual page 166

To ground the router, you need the following tools:
• Phillips (+) screwdriver, number 2
• Electrostatic discharge (ESD) grounding wrist strap
• Two 0.5-in. long stainless steel SS 316 SAE 10-32 screws, and flat washers (not provided)
• Grounding lug, Panduit LCD6-10A-L or equivalent for the ACX500 indoor router, and Panduit
LCCF6-14A-L for the ACX500 outdoor router (not provided)
• Grounding cable, minimum 6 AWG (13.3 mm
routers (not provided)
• Corrosion-preventing compound for the ACX500 outdoor router, such as NO-OX-ID (not provided)
WARNING: The ACX500 outdoor router has a provision for connecting a two-hole
grounding lug (Panduit LCCF6-14A-L). Ensure that the router is properly grounded with
6-AWG copper wire with this specified two-hole lug. Refer
Specifications" on page 91
router.
Warnung Warnung Der Outdoor-Router ACX500 bietet die Möglichkeit, eine
Erdungsklemme mit zwei Öffnungen anzuschließen (Panduit LCCF6-14A-L). Stellen Sie
sicher, dass der Router ständig über ein 6-AWG-Kabel und die entsprechende Klemme
geerdet wird.
You ground the router by connecting a grounding cable to earth ground and then attaching it to the
chassis grounding points. To ground the router:
1. Verify that a licensed electrician has attached the cable lug provided with the router to the grounding
cable.
2. Attach an ESD grounding strap to your bare wrist, and connect the other end of the strap to an
approved site ESD grounding point. See the instructions for your site.
3. Ensure that all grounding surfaces are clean and brought to a bright finish before grounding
connections are made.
4. Connect the grounding cable to a proper earth ground.
5. Detach the ESD grounding strap from the site ESD grounding point.
6. Attach an ESD grounding strap to your bare wrist, and connect the other end of the strap to an ESD
grounding point.
2
) 90° C wire for both the ACX500 indoor and outdoor
for more details on grounding specifications for the ACX500
"ACX500 Router Grounding
157