Acx500 Outdoor Router With Poe Description - Juniper ACX500 Hardware Manual

2 Cable connector ports with weather seal cap
—
Figure 10: Top View of the ACX500 Outdoor Router
GPS antenna port
1
—
NOTE: The top view and bottom view of an AC-powered ACX500 router are respectively the
same as those of a DC-powered router. The only component that appears different is the power
inlet for the two routers.

ACX500 Outdoor Router with PoE Description

The ACX500 outdoor routers with Power over Ethernet (PoE) contain three Gigabit Ethernet RJ-45
ports that support PoE+ and three Gigabit Ethernet SFP ports. Out of the three RJ-45 ports, the port
labeled 0/1/0 supports PoE++, and the ports labeled 0/1/1 and 0/1/2 support PoE+ with a maximum
system PoE power limit of 80 W. The ACX500 outdoor routers with PoE install on a pole or a wall, with
the chassis installed in a vertical orientation with the cables pointing downward and the eye bolt for
hoisting the router pointing upward.
4 Power port with weather seal cap
—
Eye bolt
2
—
51