Juniper ACX500 Hardware Manual page 176

3. Remove the screw cover cap protecting the power terminal on the faceplate.
167 shows the location of the power terminal.
Figure 59: Power Terminal Location on the ACX500 Outdoor Router
Interface port chamber with weather seal
1
—
cover
Cable connector ports with weather seal
2
—
cap
4. Power off the AC power source.
NOTE: Ensure that the power source for the ACX500 outdoor router is off before
connecting or disconnecting the power cord wires from the power source.
5. Insert the appliance coupler terminal end of the power cord into the appliance inlet on the power
source. Ensure that the power cord terminal is connected properly.
Management port chamber with weather
3
—
seal cover
Power port with weather seal cap
4
—
Figure 59 on page
167