Juniper ACX500 Hardware Manual page 178

6. Insert the AC power cord plug to the power terminal on the router. Ensure that the power plug sits
tight. See Figure 61 on page
Figure 61: Connecting AC Power Plug to the Router
NOTE: An AC-powered router need to connect with the outdoor AC power cord that is
supported with the router. Each power source must be connected to a dedicated AC power
feed and a dedicated customer-site circuit breaker. We recommend that you use a dedicated
customer-site circuit breaker rated of 20 A (100 VAC) or 16 A (240 VAC), or as required by
local electrical code.
7. Tighten the power cord plug screw.
The power cord plug screw prevents water and dust from entering the terminal.
8. Verify that the power cabling is correct, that the power cables or cords do not touch or block access
to router components, and that they do not drape where people could trip on them.
9. Power on the AC power source to the router.
10. Observe the system LED on the router. If an AC power source is functioning normally, the system
LED lights green steadily.
If the system LED is not lit, the power source is not functioning normally. Repeat the cabling
procedures.
WARNING: The AC power wiring terminals where the wires join the AC power source
must be protected from water and other particles. Use a certified waterproof enclosure
for the AC power wires.
Warnung Die AC-Anschlüsse, wo das Kabel mit der Wechselstromquelle verbunden ist
müssen von Wasser und kleinen Partikeln geschützt werden. Verwenden Sie ein
zertifiziertes wasserdichtes Gehäuse für die AC-Stromkabel.
169.
169