Console Port Connector Pinout On Acx500 Routers - Juniper ACX500 Hardware Manual

Table 27: Alarm Contact Connector Pinouts
Pin Signal Definition
Number
10 ALARM_OUT3_NO/NC
11 ALARM_OUT0_NO/NC
12 ALARM_OUT0_REF
13 ALARM_OUT1_NO/NC
14 ALARM_OUT1_REF
15 ALARM_OUT2_NO/NC

Console Port Connector Pinout on ACX500 Routers

The port labeled CONSOLE on the front panel is an asynchronous serial interface that accepts an RJ-45
connector. Use a cable with the pinouts described in
Engine to a console management device.
NOTE: You must use a shielded twisted pair (STP) cable for both outdoor and indoor router
deployments.
(Continued)
Direction CLI Port Mapping
Output Reserved for
Minor alarm
Output Output Alarm
Port 0
Output Output Alarm
Port 0
Output Output Alarm
Port 1
Output Output Alarm
Port 1
Output Reserved for
Major alarm
Table 28 on page 104
Function
External alarm output 3 (this pin is
connected to Pin 5 in closed condition)
External alarm output 0 (this pin is
connected to Pin 12 in closed
condition)
External alarm output 0 (this pin is
connected to Pin 11 in closed
condition)
External alarm output 1 (this pin is
connected to Pin 14 in closed
condition)
External alarm output 1 (this pin is
connected to Pin 13 in closed
condition)
External alarm output 2 (this pin is
connected to Pin 9 in closed condition)
to connect the Routing
103